Difference between revisions of "MainPage:Nuclear:Summer2015:LEDboard"
| Line 1: | Line 1: | ||
== Introduction == | == Introduction == | ||
| − | My projects this year were to create a new user interface for the high voltage source and to redesign the LED monitoring system.redesign a Led circuit that would contain many LEDs, activate them by address, then holds the flashing addressed Led in memory and activates another Led to blink, allowing the circuit to have multiple flashing LEDs, in the final circuit there will be around a thousand LEDs. This massive circuit board will be for a calorimeter, that will be use to run experiments on about a thousand crystal samples of lead tungsten at the Jefferson Lab. This circuit would be used to check if the PMT are functioning properly during the whole experiment. | + | My projects this year were to create a new user interface for the high voltage source and to redesign the LED monitoring system.redesign a Led circuit that would contain many LEDs, activate them by address, then holds the flashing addressed Led in memory and activates another Led to blink, allowing the circuit to have multiple flashing LEDs, in the final circuit there will be around a thousand LEDs. This massive circuit board will be for a calorimeter, that will be use to run experiments on about a thousand crystal samples of lead tungsten at the Jefferson Lab. This circuit would be used to check if the PMT are functioning properly during the whole experiment. My main project was to code a new user interface for our high voltage source. This new interface will be able to turn each channel on/off and adjust their current and voltage. The old interface was not user friendly and was hard to learn and use. This new interface will be designed to be user friendly and intuitive. |
== LED Ideas == | == LED Ideas == | ||
Revision as of 13:15, 30 July 2015
Introduction
My projects this year were to create a new user interface for the high voltage source and to redesign the LED monitoring system.redesign a Led circuit that would contain many LEDs, activate them by address, then holds the flashing addressed Led in memory and activates another Led to blink, allowing the circuit to have multiple flashing LEDs, in the final circuit there will be around a thousand LEDs. This massive circuit board will be for a calorimeter, that will be use to run experiments on about a thousand crystal samples of lead tungsten at the Jefferson Lab. This circuit would be used to check if the PMT are functioning properly during the whole experiment. My main project was to code a new user interface for our high voltage source. This new interface will be able to turn each channel on/off and adjust their current and voltage. The old interface was not user friendly and was hard to learn and use. This new interface will be designed to be user friendly and intuitive.